Published on July 9th, 2021

#1 Using the wrong nozzle: Nozzles fit on the end of the power washer spray wand and they determine the shape and intensity of the spray pattern. There are 3 main types of nozzles: fan has the widest spray pattern, flat has a more concentrated spray pattern and needle point is the most focussed of all. The fan nozzle has the largest opening and is used for large areas that you want to cover in a short time or for applying liquid soap if your pressure washer has an on-board reservoir. You can also use the fan nozzle on siding, decks and driveways. For brickwork you’ll find a flat nozzle works best. It delivers fairly concentrated cleaning action, but not so intense that it will hurt the brick. For surfaces that are resistant to damage and in need of heavy cleaning, the narrowest angle nozzle works best. Always carefully test any surface with the spray nozzle a couple of feet away at first.

#2 Failure to inspect and clean the inlet filter regularly: Power washers typically have a small screen filter in the fitting where the garden hose connects. This filter is to protect the pump from debris, but it also needs to be kept clean for proper water flow into the power washer. It only takes a second to look at the screen before connecting the garden hose, cleaning if needed.

#3 Not using enough water when power washing wood surfaces: Power washers remove dirt by knocking it off surfaces, but unless that dirt is also washed off and away by water it will still be there when the surface dries. This is especially an issue on horizontal surfaces like decks. Always make sure to power wash long enough and with enough water to carry all dirt away from the surface. Dirt, mold and mildew will not be completely removed without sufficient water flow over the surface and onto the ground.

#4 Using too much pressure when cleaning decks: It’s easy to damage wood surfaces with too much water pressure. The most common type of damage involves chunks of wood torn from the surface. That’s what you can see above. Use a wide nozzle and begin pressure washing with the nozzle tip 24” away at first. Decrease this distance only after testing in an inconspicuous place and examining the area after it has dried. Minor damage is impossible to see when the wood is wet. A certain amount of fuzziness of wood is normal after the surface has dried after pressure washing. A quick sanding with an 80-grit abrasive will solve this problem.

#5 Using too much pressure when cleaning bricks: Sure, bricks are much tougher than wood, but don’t over-estimate bricks. Excessive water pressure and too close of a nozzle position can damage mortar joints and bricks, especially older bricks. As with wood, proceed carefully and be sure to test and inspect the brick surface for damage. Only dry brick will show minor and moderate damage.

#6 Getting power washing chemicals in areas you don’t want them: This sounds like more of a danger than it is, so don’t panic. Simply be sure to follow all manufacturer’s instructions for soap and detergent. Some products such as bleach should not be mixed with certainly cleaning agents, so make yourself aware of any potential dangers ahead of time.

#7 Relying entirely on pressure washing: Sometimes pressure washing alone is not enough to get surfaces clean. As unlikely as it sounds, scrubbing with a soft brush as part of the power washing process is often necessary for cleanest results. I use a long-handled brush with a hose connection for this. It works well after an initial power washing and before a final rinse with a power washer.

#8 Not using enough soap or detergent when cleaning: If your pressure washer has a soap reservoir, be generous when applying any kind of cleaning chemical to surfaces, and let it sit for a few minutes for maximum effect before rinsing off. This will help loosen mold and grime so subsequent passes with the power washer work better.

Original Article: 8 Most Common Pressure Washer Pitfalls and How to Avoid Them

Professional Services

Contact Us